Care & Cleaning

For best results, keep the following in mind when caring for your KOHLER product:

Always test your cleaning solution on an inconspicuous area before applying to the entire surface.

Wipe surfaces clean and rinse completely with water immediately after applying cleaner.
Rinse and dry any overspray that lands on nearby surfaces. Do not allow cleaners to soak.
Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to clean surfaces.

Whirlpools & Baths

KOHLER® Cast Iron

Rinse thoroughly and use a soft cloth to wipe the product dry after each use. In the rare occurrence of stubborn stains, use abrasive cleaners sparingly, but not on Safeguard® slip-resistant surface. Use a soft nylon brush on the Safeguard surface, on the bottom of the bath. Do not use steel wool, wire brushes or abrasive sponge pads.

Acrylic

Wipe out bath/whirlpool after each use with soft cloth or squeegee. Do not use abrasive cleaners. Avoid using aerosol products on the bath surface.

Care Tip

To restore dull or scratched units: Apply white automotive polishing compound with a clean cloth. Rub scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste wax.
Do not wax areas where you walk or stand. Damaged surfaces can be repaired. Check the Yellow Pages under “Fiberglass-Repair.”

Cleaning instructions listed pertain only to their corresponding material, and are not intended for faucet cleaning. Faucet cleaning instructions for chrome and vitreous china.

Success with cleaners and procedures is dependent upon such factors as the hardness and temperature of the water, using exact measurements of ingredients, changes in cleaning formulas and the condition of the product being cleaned. Since there are variations within these factors, Kohler cannot guarantee the effectiveness of the formulas mentioned.

Click here for warranty information or call Toll Free no. 1 800 103 224.

_{* Success with cleaners and procedures is dependent upon such factors as the hardness and temperature of the water, using exact measurements of ingredients, changes in cleaning formulas and the condition of the product being cleaned. Since there are variations within these factors, Kohler cannot guarantee the effectiveness of the formulas.}